The power supply is a bit much for this scale but I think I can fine tune the electrodes to compensate and get a good ladder… and I have to find a lug lid glass jar that will screw in. This would either get you an a in science class… or expelled… ??
This ia a Soltron Electronic III Display PCB from an Ergoline Soltron Chill XL70 Tanning Bed. This board has obvious thermal defects to the L5973D voltage regulator IC as well as to the trace and the board. It is rumored that this particular board is plagued with this particular issue. The entire board new is […]
You’re getting an exclusive sneak peek at my book in its early stages! If you spot any errors, have suggestions, or find a section particularly useful (or confusing!), please share your feedback. To open in new fullscreen Google viewer window, please click here. To open in new fullscreen Google viewer window, please click here.
So I’m burning the midnight oil and burning up a few hacksaw blades and cutting up the Aurora a little bit to give a little more clearance. This V1 housing had this and I made a linear table for the V2 and it works on this one, but it sits too far forward. So I’m making that so I can slide it back. the full use of the workspace. I decided to use just a hacksaw and a small drill bit to perforate some material at specific locations. It was the least invasive, least noisy, least messy strategy. I didn’t want to run a grinder or dremel and all that. i’ll dress up those edges and it will look almost like it was […]
Step-by-Step Guide: Replacing the Alternator on a 2011 Kia Sedona EX A Comprehensive DIY Tutorial for Replacing Your Alternator Introduction This guide provides a detailed, step-by-step breakdown for replacing the alternator in your 2011 Kia Sedona EX. Always consult your vehicle’s service manual for specific instructions and torque specifications and take appropriate safety precautions. Tools […]
Testing Latency and Audio Compression UPDATE 8/12/2025 Most groups have been fully encrypted so this project is being tabled unless/until something changes.
Intro I picked up this Intelitek Expert Mill VMC-0600 with 4 axes, automatic tool changer, pneumatically actuated collet chuck, mister, touch probing, tool probing, mix and max limit switches on x, y, and z axes… and it runs a Beaglebones based Acorn board and CNC12 control software. I have experience with 3 axis gantry lasers, […]
